Handling Scissor Lift

up to 8 t load, up to 3.3 m lift

• Construction available as single scissor arm, double vertical scissor arm and double horizontal scissor arm design.
• Electro hydraulic compact power pack with:
  • Oil - initial fill
  • Pressure relief valve
  • low noise gear pump
  • Block valve (including pressure control, non-return, lowering and throttle valve) mounted in a protected area underneath the platform. It is possible to adjust the lowering rate.
  • Manual control for ON / OFF / EMERGENCY STOP with hand controller push button with 2 m cable Construction deadman" control (IP-65); also for on-site mounting.
  • CE marking and manufacture as well as construction in accordance with the applicable regulations for elevating platforms (EN-1570) and the appropriate Machinery Directives.
• Power supply 400 V (AC), 50 Hz, control voltage 24 volt (DC), IP-54
• Noise emission regulations are fulfilled by all standard series models
• Installation is possible above ground or access pit installation (installation plans are available)
• Maintenance work in a safe environment is ensured by the integrated, hinged maintenance supports
• Automatic security: stopping the lowering process in the event of a burst pipe (EN-1570). Aluminum safety contact rail, on all sides
• Platform cover made from durable sheet metal
• All steel components are cleaned and coated with primer (single coat) and two-component PU top coat (single coat)
  • Scissor blades RAL 2003 (pastel orange)
  • and underframe RAL 5015 (sky blue)
• Bearing points are all lubricated for life
• Installation, operating and maintenance instructions (German/English) with electrical, wiring and hydraulic plans as well as wear and replacement parts catalog
• Inspect and test log book for annual inspection
• Numerous accessories and special designs round off the product range